DATASHEET - DP2P-AC

Transparent Wireless Point -to- Point Bridge Professional AC series

The Dolphin Wireless professional series DP2P-AC wireless bridge provides 5GHz carrier class point-to-point connectivity between fi xed sites.

Featuring an IP67 rated integrated enclosure with an 18dBi dual polarized antenna, 802.11ac with 2x2 MiMo wireless, and a 10/100/1000 Gigabit Ethernet port with Auto-MDI/X, the DP2PAC provides reliable network links for backhaul applications such as connectivity to remote sites, VOIP, CCTV and access control. This offers a cost effective alternative to fi xed line services such as underground cabling or leased lines and can extend a networks reach across a campus, town or city area, where physical cabling is either cost prohibitive or not feasible due to access restrictions. The speed and ease of installation also makes these units ideal for quick deployment in the fi eld and offer high return on investment (ROI) Supplied as a complete kit including mounting brackets the DP2PAC comes pre-confi gured as a transparent bridge allowing a link to be established with minimal setup time. An easy to use confi guration tool provides access to a comprehensive range of link options and management features.

• Up to 220 Mbps

• Up to 540Mbps Simplex

• Range up to 5km, LOS/Near LOS*

• Power over Ethernet

• Quick and easy deployment

• 10/100/1000 Ethernet Port

The Dolphin Wireless professional series

Horizontal plane

Vertical plane

Radio Specifi cation• Wireless Onboard dual chain 5GHz 802.11ac QCA9882 wireless module with 10kV ESD protection on each RF port

• Max transmit power* 30dBm

• Supported Channels 20/40/80MHz (refer to country regulations for operation)

• Modulations OFDM, BPSK, QPSK, 16 QAM, 64QAM, DSSS, DBPSK, DQPSK, CCK

Antenna Specifi cation• Frequency 5.4 – 5.85 GHz

• Gain 2 x 18dBi

• Polarization Dual Horizontal and Vertical

• Beamwidth degree horizontal 38

• Beamwidth degree vertical 15

• VSWR < 2

• Impedance 50 ohm

• Front to back ratio 35db

• Lightning protection DC ground

General Specifi cation

• Ethernet 1 x Gigabit Ethernet with auto-MDI/X

• Power options 18V Gigabit P-POE on Ethernet Port (Non 802.3af)• Max power consumption 12W

• CPU QCA9557 720MHz CPU

• Memory 128MB DDR2 on-board memory

• Data storage On-board NAND memory chip

• Software specifi cation • IEEE 802.11 a/n wireless protocol • Nstreme & Nstreme2 (NV2) protocols with encryption • Client polling • RTS/CTS • Wireless Distribution System (WDS) • Access control list • WMM • MME wireless routing protocol

• VPN • Ipsec – Tunnel and transport mode, certifi cate or PSK, AH and ESP security protocols • Point-to-point tunnelling (OpenVPN,PPTP,PPPoE,L2TP,IPIP,EoIP) • Advanced PPP features(MLPPP,BCP) • MPLS based VPN’s • 6 to 4 tunnel support(IPv6 over IPv4 networks) • VLAN – IEEE 802.1q Virtual LAN support, MPLS

• Setup & confi guration tools • Reset beeper • Ping • Voltage and temperature monitors • Bandwidth test • Torch • Traffi c Generator, Traffi c Monitor • Web-based confi guration interface

• Dimensions (excluding brackets) 270mm x 270mm x 75mm (10,6x10,6x2,9)

• UV Protected Yes

• Min temperature -30 °c

• Max temperature + 80 °c

• Weight (excluding mounting hardware) 1.1kg

• Certifi cations FCC,CE.ROHS

* Specifi cation refers to hardware capability. Transmit power can be ad-justed within the confi guration utility. UK legislation permits a maximum of 4 Watts EIRP and therefore units supplied to UK will be pre-confi gured within this limit.

*NLOS is site specifi c and a site survey would be recommended. Obstructions will cause a drop in throughput even when a link can still be established