Embed Size (px)
Citation preview
U3e-L11
March 17, 2008
CLASSWORK
CUT WITH BAND SAW
CUT WITH BAND SAW
CUT WITH SCISSORS
CUT WITH H
ACKSAW
Note: Use a dowel to eject the waste from the pipe tool.
Make the ½” diameter holes with the pipe tool.
Motor Design, Design Drawings, and Lesson
Courtesy of Fred Nastvogel
Orthogonal Views of ProductSKETCH and LABEL
Motor Design, Design Drawings, and Lesson
Courtesy of Fred Nastvogel
U3e-L8
Orthogonal Views of ProductSKETCH and LABEL
Motor Design, Design Drawings, and Lesson
Courtesy of Fred Nastvogel
• Draft the given shapes on paper.
• Be precise with your measurements and your drawings.
• Cut out shapes and discard all paper scraps.
CLASSWORK
2 DRAWINGS2 DRAWINGS 1 DRAWING
Diameter=¼”
Motor Design, Design Drawings, and Lesson
Courtesy of Fred Nastvogel
