Upload
channing
View
215
Download
1
Embed Size (px)
DESCRIPTION
We supply overhead crane,gantry crane,jib crane,crane parts,port crane,electric hoist!Our cost performance is high,the quotation and the transportation way,belive that will make you satisfied. Welcom to inquiry! Hope to hear good news from you. We will not let you down! Warmly welcome to visit our factory! Best services and products are waiting for you! Tel: 86-371-65862089 skype: cherry.swallow Email: [email protected] Web: http://www.ytcrane.com
Citation preview
How low temperature lubrication and maintenance of YT electric hoist
1 of the electric chain hoistt chain lubrication and maintenance done;
(2) When not using the chain hoist should be done rust treatment and cleaning and maintenance,
and run up and down for 1-3 minutes, in order to maintain its performance;
3 electric chain hoist gearbox oil up to 500 hours from the start of operation of the check amount
adequate lubrication, periodic inspection every three months after the case of oil, the less you
need to refuel (LS chain hoist gearbox above the rings for the filling hole, unscrew the screws
underneath to put the hole, the hole on the side is full;
4 outdoor use electric chain hoist, rain facilities should be set up;
5 hoist parts keep dry when the operation is completed please leave the chain block wet areas,
high temperature or chemical areas to maintain its performance.
Electric chain hoist installation steps and Safety Tips
First, install HSY type 10t electric chain hoist need to install the chain box;
Second, connect the power cord;
When connecting the power cord must be cut off in advance. While the ground should be well
grounded, otherwise touch any part of the operator or chain hoist, may feel a shock feeling.
Third, lubrication chain hoist load chain;
Chain lubrication extent is a load of important factors affecting the life of the chain. Timely and
effective lubrication of the effective life of the load chain, in order to ensure the chain.
Fourth, check the alignment of the chain;
For multi-line chain chain hoist, be sure not to be flipped under hook rack. If you flip to restore it
to a normal state, to ensure that the chain of weld arranged in rows, do not twist the chain hoist
hanging loads.
Finally, check the operating voltage electric hoist;
Since HSY type electric chain hoist factory, can be specified by the user voltage or high voltage
equipment, such as 230/460V, need to check the wiring and make sure the power supply voltage
requirements are met. If not, please refer to the manual must be corrected in order to meet the
requirements of the operating voltage.
Tip:
Installation HSY type electric chain hoist, if operated at improper voltage, electric chain hoist may
be causing serious damage. To prevent this situation, you must meet the requirements needed to
ensure that the power supply wiring.