13
Assignment problem 1,2,4

Problem1,2,4

  • Upload
    hirosh1

  • View
    146

  • Download
    0

Embed Size (px)

Citation preview

Assignment

problem 1,2,4

Engine parts

Fuselage Assembly

A maker is about to assemble shuttlecock.

Nose Gear Installation

Main Gear Installation

Combination

A maker put a seal.

Difficult Point - Engine partsIt is difficult to bond while fixing the propeller of engine.So first, User should adhere D9 of propeller to D13(or D14). After that, you adhere to D12(or D15).

Difficult Point - Fuselage AssemblyWe don’t have glue. So, we think difficult we put parts on other parts of all step. Step4 is very difficult in particular. Step4 have each parts is A little heavily and size. So, It couldn't be put easily.

Tab for sticking

Difficult Point-Main Gear Main Gear is the important parts to support an Airplane! Because it was reproduced to the detail, a part was small, and assembly was very difficult.

One of difficult pointLook at this photo. Do you see parts? These parts is very small. A maker who must cut these parts from kit. It is difficult for a maker to cut parts without scissors.

3 key points-Sharing of rolesThis Assignment is the problem of doing by a group, so allotment of roles is necessary to make without waste quickly. When making a model, sync was important (Parts are separate, put together,etc). As far as it was possible, I also had to make up with the next step.-Adjust the scheduleThis Assignment is too difficult to bring to an end during class. Therefore they had to gather time outside the tuition to bring this question to an end. So it became important to behave together with a schedule.-Understand about AssignmentWhen it wasn't understood and was begun, I didn't know what I could do because there was a lot of delicate work. So it was necessary to understand a group Assignment of all the members.