Upload
jeremy-rose
View
221
Download
0
Embed Size (px)
Citation preview
1Quit
Using the VHS VCR in classrooms
Overview Use this documentation is used to show how to use the VHS players that are located in classrooms.
Learning
Objective
Independently learn how to VHS players that are located in new learning areas.
Prerequisites Knowledge of: how to operate a remote controller, how to operate a stand alone VHS player
Access to: classroom with permanently installed VHS player
Primary
Audience
Lake Forest Country Day School Faculty and Staff
Author Mara Grujanac
Technology Curriculum Coordinator
Lake Forest Country Day School
Instructions Arrows change slides. Print button prints all slides to default printer. Quit exits.
2Quit
Using the classroom VHS VCR
1. Turn on Epson projector remote control by sliding slider switchto right of red Power button toward front of remote
2. Point remote at projector & push the red Power button– The projector will beep– The status light on the projector will flash green– The projector will display auto-setup on the screen
3. Push the Video source button on projector remote
4. Push the power button on the VCR/DVD
3. Insert VHS videotape– Press Play or use Samsung remote to control VCR– Press Eject to remove videotape
4. Adjust ceiling speaker volume with Anchor remote
3Quit
Use of Classroom VHS Player
1. This is the remote for the projector. 1. Point it at the projector and push the red power
button. 2. You will hear a “beep” and the light at the bottom of
the projector will begin to flash green.
2. Switch to video input1. On the remote push the video input button
3. Turn on the VHS player
4. Put VHS tape in slot and play
5. Adjust sound with remote
4Quit
The End!
Document Control
Version Date Complete Author Description Date Approved Approved By
0.01 2007-05-17 Grujanac, Mara Initial Draft N/A N/A
Still have a question? Contact the IT Department for further assistance:
•E-mail: [email protected]
•Call: x168, x169, x170