Upload
others
View
7
Download
0
Embed Size (px)
Citation preview
Construction Dewatering
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
Professor Kamran M. Nemati
Second Semester 2005 1
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
Construction Dewatering
Lecture 13
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
1
Construction Dewatering
� The purpose of construction dewatering is to control the surface and subsurface hydrologic environment in such a way as to permit the structure to be constructed “in the dry.”
� Dewatering means “the separation of water from the soil,” or perhaps “taking the water out of the particular construction problem completely.”
� This leads to concepts like pre-drainage of soil, control of ground water, and even the improvement of physical properties of soil.
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
2
Dewatering: CAISSONS� Excavation from within the permanent structure.
� If the site is on land, the structure is built in place.
� If the site is offshore, the structure is floated into position.
� To reduce the frictional resistance between the caisson and the surrounding ground:
� Add weight
� Bentonite clay slurry is injected at the soil-structure interface.
� Jetting is used in cohesionless soils.
Construction Dewatering
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
Professor Kamran M. Nemati
Second Semester 2005 2
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
3
CAISSONS (Cont’d)� During unwatering a caisson in cohesionless soils, the upward flow from the surrounding groundwater
induces a quick condition which results in loss of strength at the bottom of excavation.
� To prevent quick condition, the head difference causing flow should be kept low.
� Caissons should not be used in the vicinity of existing structures that can be damaged due to loss of ground from beneath their foundations.
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
4
Permeability and SeepageFlow of Water in Soil
� Soils have interconnected voids through which water can flow from points of high energy to points of low energy.
� It is necessary to estimate the quantity of underground seepage for investigating problems involving the pumping of water for underground construction, and making stability analysis of earth dams and earth-retaining structures that are subjected to seepage forces.
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
5
Permeability Test(Constant Head Test)
� ASTM D2434
� q = Water flowing through the soil at a constant rate
� Q = Amount of water collected in a given time period, t
� Then: Q = qt
� Apparent velocity of the flow ⇒⇒⇒⇒
A
qv = vAq =or
H
q
Soil area, A
Q
L
Construction Dewatering
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
Professor Kamran M. Nemati
Second Semester 2005 3
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
6
Permeability (Cont’d)� In 1856, Darcy published a simple equation for the discharge velocity of water through saturated soils:
� ν : the apparent velocity
� k : the coefficient of permeability (aka: Hydraulic conductivity −−−− a material’s constant)
� i : hydraulic gradient
� By definition:
kiv =
L
Hi =
� H : the head causing flow over the distance L.
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
7
Permeability (Cont’d)
Q = qt => Q = (vA)t => Q = (ki) At
Q = k ( ) At
Solve for k : ⇒⇒⇒⇒
L
Hi =
L
H
HAt
QLk =
vAq =kiv =
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
8
Range of Permeability for Various Soils
� Gravels are 1 million times more pervious than clays
SoilPermeability Coefficient, k
(cm/sec)
Relative
Permeability
Coarse gravel Exceeds 10-1
High
Sand, clean 10-1 to 10
-3Medium
Sand, dirty 10-3 to 10
-5Low
Silt 10-5 to 10
-7Very low
Clay Less than 10-7
Impervious
Construction Dewatering
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
Professor Kamran M. Nemati
Second Semester 2005 4
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
9
Example for the Constant Head Test� For a constant head laboratory permeability test on a fine sand,the following values are given:
� Length of specimen = 10 in.
� Diameter of specimen = 2.5 in.
� Head difference = 18 in.
� Water collected in 2 minutes = 0.031 in.3
� Determine:
a. Hydraulic conductivity, k, of the soil (in./min.)
b. Discharge velocity
( )( )
( ) ( )in./min. 10175.0
25.24
18
10031.0 a. 2
2
×=
==πHAt
QLk
( ) in./min 10315.010
18 10175.0 b. 22 −− ×=
×== kiv
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
10
Permeability in the Fieldby Pumping from Wells
� In the field, the average hydraulic conductivity of a soil deposit in the direction of flow can be determined by performing pumping tests from the well.
( )
−
=
1
2
2
1
2
2
ln
R
R
HHkq
π
( )
−=
1
2
2
1
2
2
lnR
R
HH
qk
π
( )
−=
WW R
R
HH
qk ln
22π
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
11
k Determined from Pumping Tests
For D10
= 0.3 mm,
k = 2000x10-4 cm/sec
= 0.2 cm/sec
0.3
Construction Dewatering
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
Professor Kamran M. Nemati
Second Semester 2005 5
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
12
Example� Consider the case of pumping from a well in an unconfined permeable layer underlain by an impermeable stratum. Given:
� q = 26 ft3/min
� H1 = 15.7 ft at R1 = 100 ft
� H2 = 18.0 ft at R2 = 200 ft
� Calculate the hydraulic conductivity (in ft/min) of the permeable layer.
( )( ) ( )( ) ft/min 074.0
7.1518
100200ln26ln
22
1
2
2
1
2
2
=−
=
−=
ππ R
R
HH
qk
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
13
Dewatering Methods - Wellpoints
� Small pipes, up to 2.5 inches in diameter, connected to screens at the bottom and to a vacuum header pipe at the surface constitute a wellpoint system.
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
14
Dewatering Methods - Wellpoints
� Effective lifts of 15 ft. are quite common at sea level, and under certain circumstances, lifts can be increased to as much as 25 ft.
Construction Dewatering
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
Professor Kamran M. Nemati
Second Semester 2005 6
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
15
Dewatering Methods - Wellpoints
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
16
Dewatering Methods - Wellpoints
Advanced Topics in Civil EngineeringATCE-II ATCEATCEATCE---II II II
17
Dewatering Methods - Wellpoints
Multistage wellpoint system