AUDI 3G 4G MMI Video Interface 

                                              For 2009 UP With 3G 4G MMI system Round  LVDS connector 

Main Features: 1. It is suitable for 2009 up version Round connector LVDS 3G 4G MMI AudI Ai 1 Q3,A4,  A5, A6, A8, Q5, Q7 series. 

2. With 2AV input, RGBS input, Rear camera input, LVDS input 3. With 1AV output, LVDS output SYNCH 4. Built‐in CANBUS by original button MENU Switch functions. 5. Auto Rear camera Activation completely when gear is in reverse position 6. With touch operation system for external DVD, DVB T, GPS NAVI. you can by touch screen to control DVD, DVB T, GPS after learning the IR touch command code. this is excellent for add after‐market video unit. 

7. With completely plug and play to finish the installation, no need to cut, and weld any cable to finish the installation 

8. With The DIP Switcher to switch 6.5, and 7 inch monitor model application. 9. With resolution: 480*234, and 800*480, and 1246*480, by Switcher to change 

these resolution. 10. If you do not want to add the external touch screen in front of the original 

monitor, you can also use the original MENU button to control the DVD, DVB T, GPS by learning remote IR command code. 

11. Built‐in GPS function (Optional) 12. Switch by original NAV button or by Toggle switcher. 

  

At present, BMW CIC, VOLVO, BENZ 2011 NTG4.5, AUDI 3G MMI, Benz S class, Ford viode interface, etc youcan only directly to connect this RGBS cable to be as the above instruction, then can realize external DVD, DVB T , GPS BOX by touch operation after by learning IR touch Code Command!

DVD, DVB T IR cable shielding case connecto to be Ground after cut the IR header.

IR cable connection:

Please look at the above picture, IR cable is for external DVD, DVB T IR cable input connection. In common, you need to cut the DVD, and DVB T IR remote cable IR receiver head, then you can

see there are three parts in this DVD IR cable: two small cable, and one is the shielding case.

Among the two small cable, the cable connecting to the first leg of IR head receiver is the IR signal transmittion, the other small cable is useless, so you only need to connect the IR transmitton

cable the video interface IR output cable together is ok. Please look at the right picture, the RED CIRCLE marked is the Fisrt Leg of IR header, to connect the DVD, or DVB T IR cable, and the Then to finish the video interface and external DVD, DVB T IR cable connection.

To set the video interface switcher 6th PIN to down for ready IR code learing as the picture:

Then the original screen will show the touch ICON for ready learning IR CODE COMMOND as the below picture:

Finally, to make the DVD, or DVB T remote contorller point at the video interface IR eye as the below picture show ( the IR eye is inside the video interface) to start the IR command learning

According to the monitor touch ICON LOGO to press the remote controller button

correspondly, you must do not exit this learning situation unit to finish the

all touch ICON IR command learning, otherwise, the learning will be failed. after finish

all the touch ICON learning then to pull up and down video interface switch 6th PINS

5-6 times to calibration, until the monitor appear the Cross LOGO, then stop to pull the

DIP6, and start to touch the CROSS LOGO to calibration touch functions. See the below

Pictures:

After calibration, you can touch the monitor

to operate the DVD, or DVB T by these touch ICON